The MLRK1-CAL (CRLP98-UL-M-KIT) is a high quality, cost effective method of converting an Cal Royal 2200 & 9800 series device to an electrified latch pullback exit device. The kit retracts the push pad, the device can be electrically dogged allowing the device to remain in a push/pull state, for as long as is desired. Patent Pending Push to Start (PTS)Technology allows for an easy post-installation adjustment of the latch/latches. Last but not least, all MLRK1-CAL feature an updated MM4S module with 2 different torque settings from energy conscious to high torque to get the tough jobs done! The MLRK1-CAL is a cost-effective and straightforward way to upgrade your Cal Royal 2200 & 9800 series device to motor-driven latch retraction in the field. UL Listed + 3 Year manufacturers warranty. Easy installation.
Equal to Cal Royal part #FLR2298 and SDC LR100-CAK-EM
Previous model # CRLP98-UL-M-KIT
- “PTS” Push to set technology
- Easy installation - underneath the push pad for ultimate cutdown
- Fast, quiet, smooth
- True Electronic Dogging - Full push pad retraction
- UL Listed
- MM4S Smart Module: On-board diagnostics with audible feedback for adjustment and power issues
- Remote MM4S module for easy accessibility y & servicing.
- “PTS”: 5-second electronic adjustment for easy post-installation adjustment
- Electric dogging rated for continuous duty - Auto re-engage if push pad is pulled from dogged position • Low Current Draw - Field switchable to “High Torque” mode
- Up to 300’ wire run with 2-18ga wire - Long wire runs provide the installer with the convenience of placing the Command locking hardware power supply in a centralized location; i.e., the same closet as the access control panel
- 8’ cable with Quick Connect for MM4S module to easily connect to power supply lead
- Request-to-exit kit available
- Voltage range – 24 to 28 VDC
- System protection – unit shutdown when voltage exceeds 28VDC
- Standard Torque - Average Current Peak: 900A, Average Current Hold: 215mA
- High Torque - Average Current Peak: 2A, Average Current Hold: 250mA
- PTS adjustment – approx. 1/4”